www.8devices.com
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Author |
Message |
juerg5524
Joined: 20 Jan 2017, 10:01 Posts: 5
|
Hi
I plug usb2can in. dmesg:
[10666.567363] usb 1-1.2: new full-speed USB device number 20 using xhci_hcd [10666.647570] usb 1-1.2: device descriptor read/64, error -32 [10666.860222] usb 1-1.2: New USB device found, idVendor=0483, idProduct=1234 [10666.860230] usb 1-1.2: New USB device strings: Mfr=1, Product=2, SerialNumber=3 [10666.860235] usb 1-1.2: Product: USB2CAN converter [10666.860241] usb 1-1.2: Manufacturer: edevices [10666.860245] usb 1-1.2: SerialNumber: ED000200 [10666.862603] usb_8dev 1-1.2:1.0 can0: firmware: 1.7, hardware: 1.0
then
sudo ip link set can0 up type can bitrate 20000
after that, ip address:
20: can0: <NOARP,UP,LOWER_UP,ECHO> mtu 16 qdisc pfifo_fast state UNKNOWN group default qlen 10 link/can
Unfortunately, there is no "/dev/can0"!
Please, can you give me a hint?
Greetings Jürg
|
09 Jan 2019, 13:33 |
|
|
juerg5524
Joined: 20 Jan 2017, 10:01 Posts: 5
|
I also tried to use the source files from github. The script I used as root:
ip link set can0 down rmmod usb_8dev
make clean make
modprobe can-raw modprobe can-dev insmod usb_8dev.ko
ip link set can0 up type can bitrate 20000
|
10 Jan 2019, 10:02 |
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: No registered users |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum
|
|